The Scoop Single-Serve Coffeemaker goes where no coffeemaker has gone before, brewing hotter, faster and better-tasting coffee than most gourmet machines out there. And, its benefits don’t stop there. The Scoop Coffeemaker utilizes the simplicity of ground coffee and brews a customizable cup quickly: an 8 oz. cup in less than 90 seconds or a 14 oz. travel mug in under two-and-a-half minutes. Aside from its versatility in using inexpensive coffee grounds to brew a great-tasting cup, The...
Some machines use a single boiler kept at steaming temperature, but water for brewing is passed through a heat exchanger, taking some heat from the steam without rising to the same temperature. Although the water for brewing remains at a lower range than that required for steaming milk, it is still too hot for proper coffee extraction without first cooling; thus this type of machine requires a cooling flush of 4–6 seconds prior to the first espresso pull. Once the machine is dialed into the proper temperature, as many shots can be pulled as required without refreshing. However, if the user leaves the machine idle again for some period, the flushing process will need to be repeated. The HX variety is found in many mid-range machines and many users install thermometers to assist them is dialing in correct temperatures. There is some controversy as to the temperature stability of the brewing water, since it is indirectly converted from steaming temperature to brewing temperature, rather than kept at a brewing temperature.
Let’s circle back to that extra-long brew time. There are two factors that didn’t make it an automatic “no” for us. The first is that the OXO On 12-Cup is programmable. Like our experts say, grinding coffee in advance isn’t going to make the most perfect cup of coffee. But the fact that you can program the machine’s “wake-up time” to start brewing and have coffee ready when you are takes the sting out of the wait.
Our coffee machines are easy to use, and are designed with glass or thermal carafes and non-stick warming plates to keep your drip coffee warm long after the brewing process is over. Your coffee machine will alert you when it has finished brewing, and, depending on the model, will have either an automatic shut-off or a freshness indicator to ensure you never need to drink stale coffee again.
The method for making coffee in a percolator had barely changed since its introduction in the early part of the 20th century. However, in 1970 General Foods Corporation introduced Max Pax, the first commercially available "ground coffee filter rings". The Max Pax filters were named so as to compliment General Foods' Maxwell House coffee brand. The Max Pax coffee filter rings were designed for use in percolators, and each ring contained a pre-measured amount of coffee grounds that were sealed in a self-contained paper filter. The sealed rings resembled the shape of a doughnut, and the small hole in the middle of the ring enabled the coffee filter ring to be placed in the metal percolator basket around the protruding convection (percolator) tube.
What Amazon users have to say: Reviewers love that you can customize the amount of froth in your drink. They also love the simplicity of use: just add water, add milk to the frother container, add coffee, and you’re ready to go. A major plus for the aficionados: this machine still gives you the option to use your own coffee grounds instead of pods, allowing for fresh and customizable brews. Several users noted how the quality of the espresso is “amazing for the price” of the machine.
Only two optional settings are available: You can control the heating element under the carafe and turn down the temperature if desired. Other than that, the Moccamaster doesn't have—and doesn't need—anything else. Technivorm boasts that its heating element can get water between 196ºF and 205ºF, which specialists say is the ideal temperature for brewing coffee.
Because the coffee grounds remain in direct contact with the brewing water and the grounds are filtered from the water via a mesh instead of a paper filter, coffee brewed with the cafetiere captures more of the coffee's flavour and essential oils, which would become trapped in a traditional drip brew machine's paper filters. As with drip-brewed coffee, cafetiere coffee can be brewed to any strength by adjusting the amount of ground coffee which is brewed. If the used grounds remain in the drink after brewing, French pressed coffee left to stand can become "bitter", though this is an effect that many users of cafetiere consider beneficial. For a 1⁄2-litre (0.11 imp gal; 0.13 US gal) cafetiere, the contents are considered spoiled, by some reports, after around 20 minutes. Other approaches consider a brew period that may extend to hours as a method of superior production.
That said, it’s not as elegant to use as the OXO machines. (Nor is it as nice to look at. One tester described its tall, bulbous body and squat carafe as “UFO-like.”) Take its eight-button controls, for example, which you use to toggle among brew modes, scroll up and down within the menu, and engage a manual brewing feature. Programming it to start brewing at a certain time was about as intuitive as setting an alarm on a clock radio — easy enough, but more technical than sleek. OXO definitely feels like the future; Behmor is more, “If it ain’t broke, why fix it?”
An early variant technique, called a balance siphon, was to have the two chambers arranged side-by-side on a sort of scale-like device, with a counterweight attached opposite the initial (or heating) chamber. Once the near-boiling water was forced from the heating chamber into the brewing one, the counterweight was activated, causing a spring-loaded snuffer to come down over the flame, thus turning "off" the heat, and allowing the cooled water to return to the original chamber. In this way, a sort of primitive 'automatic' brewing method was achieved.
“I purchased the machine for myself as a birthday present, and I’ve had it for about six weeks. We have a Pavoni espresso machine, which my husband loves for his espressos, but I think it’s a pain for making lattes: grinding the beans, tamping down the pod, ‘pulling’ the lever (which will be really hard if you tamp it too densely), steaming the milk, and then cleaning the steaming wand, not to mention what a pain it is to refill the water chamber (turn off, wait till pressure is gone, then you can refill). Why am I listing all of these steps? Because that’s what you don’t have to worry about with the Lattissima! Here are my steps now: Turn on the machine, get the milk container out of the fridge and plug it into the front, put an espresso capsule in the top, stick a mug under the spout, and push the Latte button. Done. You do need to clean the frother, which is just putting another cup under the spout, turn the milk to “clean” and let it clean, then you can remove the milk container and stick it in the fridge. I clean the milk container once a week, soaking all the pieces in a bowl of hot, soapy water for a few hours.”
Our brew-performance tests measure the brew temperature and contact time (how long water stays within a sweet spot of 195° to 205° F for brewing). We measure concentration using a refractometer, a device that measures the amount of coffee dissolved in each brew. Our convenience tests look at how easy it is to set timers, fill the reservoir, clean the machine, and more. And for the first time, we’re incorporating predicted reliability and owner satisfaction ratings into the new Overall Score for each model. We determine these ratings for each drip coffee maker brand using survey data collected from thousands of CR members.