Semi-automatic espresso machines are just that—semi-automatic. Some of the steps are automated, but many are not. This allows the user to put their personal stamp on the final product but without doing some of the tedious steps that are involved in making an espresso on the stove top. Here’s a look at some of the features that make a semi-automatic espresso machine such a great pickup for the ultimate espresso lover:
Prior to the introduction of pre-measured self-contained ground coffee filter rings, fresh coffee grounds were measured out in scoopfuls and placed into the metal percolator basket. This process enabled small amounts of coffee grounds to leak into the fresh coffee. Additionally, the process left wet grounds in the percolator basket, which were very tedious to clean. The benefit of the Max Pax coffee filter rings was two-fold: First, because the amount of coffee contained in the rings was pre-measured, it negated the need to measure each scoop and then place it in the metal percolator basket. Second, the filter paper was strong enough to hold all the coffee grounds within the sealed paper. After use, the coffee filter ring could be easily removed from the basket and discarded. This saved the consumer from the tedious task of cleaning out the remaining wet coffee grounds from the percolator basket.
The Moccamaster isn't for everyone. Handmade in the Netherlands, it costs around $300—and would never win an award for value. It lacks a programmable timer, and it was also bit more difficult to set up than the rest of the coffee makers—in fact most were ready to go right out of the box. But a quick look at the instruction diagram should clear up any confusion, and the end result is well worth the effort.
Like the OXO machines, it has only one button on its interface. Unlike the OXO machines, that button does only one thing: start the brewing process. If you hold it down until it blinks, you’ll activate the pre-infusion; otherwise a simple click gets it going. Brewing a full pot of eight cups took us about seven minutes, by far the fastest of any of our top picks — which is a good thing, considering you can’t program it to start brewing before you wake up.
Hand-tooled and bench-tested in Italy, this espresso maker looks, works, and performs like it belongs in a small coffee shop, despite fitting tidily on your kitchen counter. This machine is built to last 10 to 15 years; less expensive machines at best might survive the five-year mark, and some can’t be expected to reach three. We also loved the sheer quality of every part included with our Rocket. The heft metal tamp fits perfectly in the machine’s own portafilter baskets and improved the shot-making experience of other machines when we used it with theirs.
The Baratza Encore is simplicity defined and our top coffee grinder. This burr grinder has a 40-setting grind size selector, an on-off switch for continuous grinding, and a push-button for manual control. That's it. Other grinders include complicated timers, built-in scales, strength adjustment sliders, and other doodads, but Baratza suggests that you don't need them—and they're right. Measure your beans using a separate scale, grind them fresh for each cup. That's the way to do it.
Only two optional settings are available: You can control the heating element under the carafe and turn down the temperature if desired. Other than that, the Moccamaster doesn't have—and doesn't need—anything else. Technivorm boasts that its heating element can get water between 196ºF and 205ºF, which specialists say is the ideal temperature for brewing coffee.
Running hard water through your coffee equipment can lead to mineral buildup and calcification on your heating elements. If you’re looking to get the most out of your commercial coffee maker , then it’s important to make sure it’s properly cleaned. Cleaning your coffee maker will not only prolong its life span, but it will also improve the taste of your coffee. You should be cleaning and deliming your machine at least once every six months, however if the water you use is extremely hard, you may need to clean it every month. Follow our video and step-by-step instructions to get your coffee maker back in top shape, and don't forget to set up a water filtration system for your coffee equipment to cut down on mineral buildup in the future. Step-by-Step Instructions for How to Clean a Coffee Maker 1. Unplug the coffee maker. 2. Wipe down the machine with a damp towel. After you're finished wiping down your machine, you should plug it back in to begin the deliming process. 3. Mix 10 oz. of lemon juice with 32 oz. of water. 4. Pour the mixture into the water reservoir. 5. Turn your coffee machine on as if you are brewing a pot of coffee. 6. Once your coffee machine has finished its brewing cycle, remove the machine's spray head. 7. Remove any residue that may be blocking the holes on the spray head. 8. Insert a deliming spring into the opening where the spray head was. In a sawing motion, move the deliming spring back and forth about 5-6 times. Run two or three brewing cycles with plain water in order to remove any traces of lemon water solution. 9. Wash the coffee filter with warm, soapy water.
“This little coffee maker is PERFECT! So easy and reliable. It works great for a household with little kitchen space and light coffee drinkers. It has upped my coffee intake because it’s so easy to make coffee now! Plus, to be able to have it waiting in the morning and encourage me to actually get out of bed on time is well worth the price of this little machine.”
Because the coffee grounds remain in direct contact with the brewing water and the grounds are filtered from the water via a mesh instead of a paper filter, coffee brewed with the cafetiere captures more of the coffee's flavour and essential oils, which would become trapped in a traditional drip brew machine's paper filters. As with drip-brewed coffee, cafetiere coffee can be brewed to any strength by adjusting the amount of ground coffee which is brewed. If the used grounds remain in the drink after brewing, French pressed coffee left to stand can become "bitter", though this is an effect that many users of cafetiere consider beneficial. For a 1⁄2-litre (0.11 imp gal; 0.13 US gal) cafetiere, the contents are considered spoiled, by some reports, after around 20 minutes. Other approaches consider a brew period that may extend to hours as a method of superior production.
Bunn-O-Matic came out with a different drip-brew machine. In this type of coffeemaker, the machine uses a holding tank or boiler pre-filled with water. When the machine is turned on, all of the water in the holding tank is brought to near boiling point (approximately 200–207 °F or 93–97 °C) using a thermostatically-controlled heating element. When water is poured into a top-mounted tray, it descends into a funnel and tube which delivers the cold water to the bottom of the boiler. The less-dense hot water in the boiler is displaced out of the tank and into a tube leading to the spray head, where it drips into a brew basket containing the ground coffee. The pourover, water displacement method of coffeemaking tends to produce brewed coffee at a much faster rate than standard drip designs. Its primary disadvantage is increased electricity consumption in order to preheat the water in the boiler. Additionally, the water displacement method is most efficient when used to brew coffee at the machine's maximum or near-maximum capacity, as typically found in restaurant or office usage. In 1963, Bunn introduced the first automatic coffee brewer, which connected to a waterline for an automatic water feed.
Tamp: To ensure the espresso is evenly packed, your machine comes with a tamp, which you’ll press into the basket against the grounds. This step is important: When you pull a shot, the water will go to the place of least resistance, avoiding densely packed areas. This denser espresso won’t be properly saturated, making it under-extracted and sour, while the looser espresso will be over-extracted and bitter.
Espresso shots need to be pulled between 186 and 194 degrees F. If the water is too cold when it hits the espresso, the shot tastes sour. Too hot, and it tastes burnt. It’s trickier to hit this window if you also want your machine to steam milk, since steam requires a higher temperature — at least 212 degrees. But we struggled to get several of our machines just to pull decent espresso, never mind the milk. Sour shots were a clear sign that the water wasn’t hot enough; scorched shots indicated that the water climbed over 200 degrees.
“I grind the beans in a Hario hand grinder gifted from my brother to me when he upgraded to a fancy electric one. Using the hand grinder is meditative. It feels like you’re ‘earning’ your morning coffee a little bit more. At home, I use a Muji porcelain pour-over, but when I’m at my family’s house in metro Detroit, I love using their Bonavita BV1800SS. Unfortunately, I don’t have one of my own, but seriously, you can’t fuck it up. Super-easy and delicious every single time.” — Kimberly Chou, co-director of Food Book Fair
This machine is extremely consistent and it brews an excellent espresso or cup of coffee. It also looks like Darth Vader manifested as a coffee machine: it's sleek and black and is definitely what our coffee makers will look like when we're all living on the moon. If your kitchen aesthetic is Space Chic, this machine is for you. It takes the joy and skill out of brewing your own espresso, but it works extremely well and is great for making an almost cafe-quality cup of coffee at home in no time and with very little effort.
Some home pump espresso machines use a single chamber both to heat water to brewing temperature and to boil water for steaming milk. However, they can perform only one operation at a time, requiring a warm up period between the execution of espresso pull and the milk frothing process. Since the temperature for brewing is less than the temperature for creating steam the machine requires time to make the transition from one mode to the other. Moreover, after the brewing process, a single boiler will expel (usually minor) quantities of water through the steam wand that were left over from brewing, which can cause the steam heated milk to then have a slightly watered down taste. To avoid this, the leftover water needs to be collected from the steam wand before steaming of the milk should begin. SB/DUs are generally found within the lower tiers of enthusiast home models, with steam wands being a simple and valued addition.
The built-in burr grinder is high quality, and you can easily adjust the grind size and amount with a dial on the front of the machine. You can choose to use either a single- or double-wall filter basket, and the grinder will automatically adjust to give you the right about of coffee grounds for your brew. Reviewers love that it comes with the grinder and praise its quality.
Making the perfect espresso can be a labor of love, but not everyone who wants to drink espresso wants to do all that labor. Pod-based machines make it easier, but then you have fewer type of coffee to choose from. This machine solves both of those problems since it has adapters for most of the popular pods, including Nespresso, Dolce Gusto, K-Fee, or Verismo by Starbucks, and you can also use your own fresh ground coffee.
Brew yourself a fresh mug of coffee with the sleek, stylish, and highly functional Farberware 8-Cup Classic Yosemite Percolator. A must-have countertop appliance, this percolator makes sure that your morning coffee rituals are refreshing and energetic. Featuring immaculate lines and a fine finesse, it has a classic design that looks great with most kitchen decors. Compact, easy to operate, and space-saving, it can easily be accommodated on your kitchen counter without occupying much space. The...