With the introduction of the electric drip coffee maker for the home in the early 1970s, the popularity of percolators plummeted, and so did the market for the self-contained ground coffee filters. In 1976, General Foods discontinued the manufacture of Max Pax, and by the end of the decade, even generic ground coffee filter rings were no longer available on U.S. supermarket shelves.
In later years, coffeemakers began to adopt more standardized forms commensurate with a large increase in the scale of production required to meet postwar consumer demand. Plastics and composite materials began to replace metal, particularly with the advent of newer electric drip coffeemakers in the 1970s. During the 1990s, consumer demand for more attractive appliances to complement expensive modern kitchens resulted in a new wave of redesigned coffeemakers in a wider range of available colors and styles.
The De'Longhi comes with a durable, high-quality stainless steel boiler which would serve you well over time. Other notable features include a swivel jet frother for easy cappuccino and latte prep, a dual-function filter holder that gives you a choice between ground coffee and pods, and a self-priming function which we recommend for the absolute best results.
Some home pump espresso machines use a single chamber both to heat water to brewing temperature and to boil water for steaming milk. However, they can perform only one operation at a time, requiring a warm up period between the execution of espresso pull and the milk frothing process. Since the temperature for brewing is less than the temperature for creating steam the machine requires time to make the transition from one mode to the other. Moreover, after the brewing process, a single boiler will expel (usually minor) quantities of water through the steam wand that were left over from brewing, which can cause the steam heated milk to then have a slightly watered down taste. To avoid this, the leftover water needs to be collected from the steam wand before steaming of the milk should begin. SB/DUs are generally found within the lower tiers of enthusiast home models, with steam wands being a simple and valued addition.
Bunn-O-Matic came out with a different drip-brew machine. In this type of coffeemaker, the machine uses a holding tank or boiler pre-filled with water. When the machine is turned on, all of the water in the holding tank is brought to near boiling point (approximately 200–207 °F or 93–97 °C) using a thermostatically-controlled heating element. When water is poured into a top-mounted tray, it descends into a funnel and tube which delivers the cold water to the bottom of the boiler. The less-dense hot water in the boiler is displaced out of the tank and into a tube leading to the spray head, where it drips into a brew basket containing the ground coffee. The pourover, water displacement method of coffeemaking tends to produce brewed coffee at a much faster rate than standard drip designs. Its primary disadvantage is increased electricity consumption in order to preheat the water in the boiler. Additionally, the water displacement method is most efficient when used to brew coffee at the machine's maximum or near-maximum capacity, as typically found in restaurant or office usage. In 1963, Bunn introduced the first automatic coffee brewer, which connected to a waterline for an automatic water feed.
It can take a little while to get to know the ins and outs of a new coffee maker. In CR’s labs, each drip coffee maker we test brews roughly 65 cups by the time our engineers are through with it. And brewing is just one of many aspects we look at. We test for handling and convenience, too, so you can choose a model that helps you sail through morning madness.